Stichting Laka

Publicatie Laka-bibliotheek:
Safeguards Agreement under NPT between [ ] and the IAEA. M-09 (Fuel fabrication plant with three parallel process areas) (1976)

AuteurIAEA
Datumoktober 1976
Classificatie6.03.1.30/63 (PROLIFERATIE - NPV - CONTROLE/SAFEGUARDS)
Voorkant

Uit de publicatie:

M-09
(Fuel fabrication plant with three parallel process areas)
October 1976

Explanatory Note

This model is intended to provide guidance for the preparation of a facility
attachment pertaining to a fabrication plant, which has more than one process
area. (For a plant with one process area, there is a separate model, M-03).

The description of the plant in Code 1.4 is obviously illustrative, and the
formulation of Codes 3 and 4 has been geared to suit the description.

The repetitive pattern of numbering KMPs for MBAs 2, 3 and 4 has been dictated
by the present limitation of one numeral for E D P purposes. There would be no
objection to the KMPs being numbered consecutively, provided the number of
KMPs does not exceed 9.

In regard to KMP Code 2 of Code 4.1 for MBA 1, when material is shipped to other
MBAs it will be measured by the operator either on shipment from MBA 1 or on
receipt in one of the other MBAs. In the case of shipment from MBA 1 to an outside
facility, the operator may do so either on the basis of the supplier's data or of
his own measurements.

In Codes 4.1 and 4.2 the column for material description codes should be completed,
depending on whether the old or the new material description codes are in use in the
country concerned.

In Code 7.1, the mode of intermittent routine inspections should not be regarded
as of universal application. The mode would depend, inter alia, on the throughput.

Deze publicatie is alleen op papier bij Laka beschikbaar, niet als pdf.
Publicaties zijn te leen of informeer of we een kopie kunnen maken. Soms, als we tijd hebben, lukt dat tegen kostprijs van de kopieën.